Skip to main content
Avalara Help Center

Use billing address for tax calculation

This article applies to:Connector for NetSuite

Connector for NetSuite automatically uses the shipping address on a transaction to calculate tax. However, you can change this functionality and enable the connector to use the billing address instead of the shipping address for calculating the tax on a transaction.

Before you begin

Once you enable this feature, a new transaction always uses the billing address instead of the shipping address. For an existing transaction, you need to manually enable this functionality by using the Use Bill to Address for Tax calculation checkbox on the Invoices page in NetSuite.

Steps

  1. In NetSuite, go to Avalara > Setup> Configure Avalara.
  2. Go to the Tax Calculation tab and select Use Bill to Address for Tax calculation.
  3. Select Save.

Once you enable this feature, the Use Bill to Address for Tax calculation checkbox is added in the Classification section of the Invoices page 

NetSuite.JPG

After this feature is enabled and you prefer to use the shipping address instead of the billing address, clear Use Bill to Address for Tax calculation to disable the functionality on an individual transaction. 

  • Was this article helpful?